Kraang Finds
More ▾
Products About
Resin & Epoxy CalPalmy

CalPalmy Bubble Removing Heat Tool for Epoxy Resin

A small craft heat tool that tops out at 390 °F — warm enough to pop surface bubbles, far gentler than a torch.

An ink paw print on a white card next to the same print sealed in a glossy round epoxy resin keepsake
Best for Popping bubbles in fresh resin poursdrying paint and inkembossing and shrink film

Stirring puts air into resin, and the bubbles that rise to the surface have to be popped before it sets. A torch does that in a second, but mold makers warn that flame damages silicone. Warm air is the gentler way, and a small craft heat tool is easier to aim at one mold cavity than a hair dryer, which mostly blows the resin around.

A few seconds per pour is all it takes, so the short run time isn’t a problem for this job.

Pro tip CalPalmy says to hold the tool at a 45-degree angle, so hot air doesn’t flow back into it, and to keep the rear intake clear. Stay 6–8 in (15–20 cm) above the resin and keep moving; stop as soon as the surface clears.

Why we like it

  • ✓Heats up to 390 °F (200 °C), well below a workshop heat gun
  • ✓Slim body, 8.8 in long and 1.8 in wide, held in one hand
  • ✓Fold-out stainless steel stand for hands-free use
  • ✓No open flame near silicone molds

Keep in mind

  • !Run it for under 3 minutes at a time — the listing warns the plastic parts can melt beyond that
  • !The cord is only 38 in (97 cm), so the pour has to happen near an outlet
  • !This link is the pink one; other colors are on the same listing
Max temperature
390 °F (200 °C)
Size
8.8 × 1.8 in
Cord
38 in (97 cm)
Stand
Fold-out stainless steel
Run time
Under 3 minutes at a stretch
Weight
0.27 kg (0.6 lb)

As an Amazon Associate I earn from qualifying purchases. If you buy through a link on this page we may earn a small commission, at no extra cost to you. How this works.

Featured in

More Resin & Epoxy