Kraang Finds
More ▾
Products About
Maker Gear Bondic

Bondic UV Liquid Plastic Welder Starter Kit, 4 g

A liquid plastic that stays liquid until you hit it with the UV light — rebuild a broken tab or a split cable jacket in layers, four seconds at a time.

Maker workbench with a chair clamped for repair and a hot glue gun, accelerator spray, epoxy syringe, UV pen and glue injector laid out
Best for Rebuilding broken plastic tabsfrayed cable jacketseyeglass and toy repairsfilling and shaping small parts

Some repairs have nothing left to glue: the snapped tab that held a battery cover, a charging cable whose jacket has split at the plug, a missing corner on a plastic clip. Super glue needs two faces to join. A UV resin pen rebuilds the missing piece instead: lay down a bead, cure it with the light, lay down another, until the tab is back.

Because it stays liquid until the light is on it, you can push it into place, shape it and only then set it. The honest part is what it is: a clear plastic that locks onto a roughened surface, not an adhesive that soaks into a clean break. Scuff the plastic, build the repair over a wider area than the break, and it holds. Fill a crack with it and press two smooth parts together, and it won’t.

Pro tip Thin layers, each cured for the full few seconds, beat one thick blob that stays soft underneath. Roughen the surface with sandpaper or a file first, and keep the applicator tip out of direct sunlight — daylight cures it too.

Why we like it

  • ✓Doesn't set until the UV light is on it, so you can shape it first and it never dries out in the tube
  • ✓Cures in about 4 seconds under the included LED, Bondic says
  • ✓Builds up in layers to fill a gap or replace a missing piece — not just a thin glue line
  • ✓Waterproof and heat resistant once cured, and can be sanded and painted
  • ✓Pen-sized applicator with the UV LED, in a small metal case that fits a drawer or a pocket

Keep in mind

  • !It isn't super glue — cured Bondic is a plastic that grips rough surfaces, so it holds a tab or a bridge, not two smooth faces pressed together
  • !Only cures where the light reaches; a blind joint between two parts stays liquid inside
  • !4 g goes quickly if you use it as a filler
Type
UV-cured liquid plastic
Size
4 g tube
Cure
About 4 s under the LED (Bondic)
Finish
Clear, sandable, paintable
Included
Applicator, LED UV light, 4 g liquid, metal case

As an Amazon Associate I earn from qualifying purchases. If you buy through a link on this page we may earn a small commission, at no extra cost to you. How this works.

Featured in

More Maker Gear