Kraang Finds
More ▾
Products About
Maker Gear Big Horn

Big Horn 19408 High Pressure Glue Injector with 2 Brass Tips

Pushes wood glue deep into a loose chair rung, a split board or a lifting veneer edge — into the joint, not just over it.

Maker workbench with a chair clamped for repair and a hot glue gun, accelerator spray, epoxy syringe, UV pen and glue injector laid out
Best for Loose chair and table jointssplits and cracks in woodlifting veneerfurniture repairs

A wobbly chair is almost never a broken chair. The glue in one joint has let go, and the fix is getting fresh glue into that joint without knocking the whole thing apart. Smearing glue on the outside of the joint does nothing; it has to go where the old glue was.

An injector does that. Drill a small hole into the joint if there’s no gap, push the brass tip in, and the plunger forces glue through to the end of the rung. The same tool fills a split in a board from the inside and slides glue under a bubble of veneer through a slit. Clamp it, wipe the squeeze-out and the chair stops rocking.

Pro tip Rinse the barrel and tip with warm water the minute you’re done. Dried wood glue in a 1/32 in tip is a tool you throw away. If thick glue won’t pass the fine tip, a few drops of water in the barrel thins it enough.

Why we like it

  • ✓Big Horn rates it at up to 550 psi — enough to push wood glue through a needle-sized tip into a tight joint
  • ✓Two brass tips, 1/16 in and 1/32 in, for a joint gap or a hairline crack
  • ✓T-handle plunger gives real leverage without the barrel flexing
  • ✓Graduated clear barrel so you can see how much glue is left
  • ✓Metal tips and seals rinse out and go again, unlike a disposable syringe

Keep in mind

  • !For water-based glues only (wood glue, PVA); CA or epoxy would set inside it
  • !Must be rinsed right after use, or the next job starts with a plugged tip
  • !A small barrel — fine for repairs, not for a big glue-up
Capacity
20 ml (from the barrel scale)
Pressure
Up to 550 psi (Big Horn)
Tips
Brass, 1/16 in and 1/32 in
For
Water-based glues
Weight
About 4 oz (0.11 kg)
Model
19408

As an Amazon Associate I earn from qualifying purchases. If you buy through a link on this page we may earn a small commission, at no extra cost to you. How this works.

Featured in

More Maker Gear